Otto

From TAMI
Jump to navigationJump to search

otto pro

this is an open source soldering "station" based on the JBC and using STM32 (STM32F072C8Tx)
Otter-Iron-PRO kicad github

parts

  1. JBC245 handle - 60$
  2. tips - 25$
  3. pcb - 5$
  4. parts ~20$


P4j8l.png


 q: why not TS100/TS80?
 a: the most important part of a station is the handle/cable. 
    the JBC handle (you see in pic) is amazing. 
 q: wait! the firmware is not ready
 a: based on his former work, it will just get better. it all ready works
    the hardware isn't expected to change. but yes, if you dont want to mess with firmware burning, move along