tamiwiki:projects:attami
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| tamiwiki:projects:attami [2023/05/31 15:07] – yair | tamiwiki:projects:attami [2023/06/20 11:37] (current) – [LOG] yair | ||
|---|---|---|---|
| Line 21: | Line 21: | ||
| + | === Installation and Setup on Arduino IDE === | ||
| + | |||
| + | - Open the Arduino IDE and go to " | ||
| + | - Add the following URL to the " | ||
| + | - Click " | ||
| + | - Next, navigate to " | ||
| + | - In the Boards Manager window, search for " | ||
| + | - Once you find it, click on it and then click the " | ||
| + | - Wait for the installation process to complete. | ||
| + | - After installation, | ||
| + | - Then, select " | ||
| + | - You are now ready to flash your first AtTami. | ||
| ===== LOG ===== | ===== LOG ===== | ||
| + | === update #7 === | ||
| + | working on tzvi [[https:// | ||
| + | added:\\ | ||
| + | * an OLED display (to monitor temp and stage without pesky serial) | ||
| + | * a potentiometer to switch between two modes | ||
| + | * mode 99 - if pot is set to 0 on reset the reflow controller will hit a certian temprature and nothing else. | ||
| + | * mode 1-5 - if pot is not at 0, it will run the regualt reflow profile. | ||
| + | * switch from 6.5AC-DC psu to a smaller 5V supply. | ||
| + | |||
| + | {{: | ||
| + | {{: | ||
| === update #6 === | === update #6 === | ||
| we tried working out | we tried working out | ||
tamiwiki/projects/attami.1685534828.txt.gz · Last modified: 2023/05/31 15:07 by yair
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
