Differences

This shows you the differences between two versions of the page.

--- tamiwiki:projects:drawbot [2025/12/16 10:11] – yair
+++ tamiwiki:projects:drawbot [2025/12/16 10:11] (current) – yair
@@ Line 3: / Line 3: @@
 there are three repos needed to get this going
   * GRBL [[https://git.telavivmakers.space/yair/grbl|git]] - the firmware running on the arduino+grbl shield
-  * drawbot_LY - [[https://git.telavivmakers.space/yair/drawbot_LY|git]] the Inkscape extension that converts vector to gcode
+  * drawbot_LY [[https://git.telavivmakers.space/yair/drawbot_LY|git]] - the Inkscape extension that converts vector to gcode
   * Universal gcode sender- this [[https://universalgcodesender.com/|java app]] loads the gcode above and sends the gcode commands one by one to the Arduino over serial.

TAMI - wiki